![]() This technique is necessary only on the most stubborn wheels, and sometimes on wide ATV wheels, on the side opposite of the drop center. Break the bead in one spot, extending the Ram ony about 3/4″-1″, and then work your way around, every few inches…this will minimize how much you have to stretch the Bead Bundle. Instead, you need to take more frequent, smaller ‘bites’ around the rim. For these cases, even some very stubborn ATV wheels, to prevent bending the ram foot you need to avoid trying to use the full travel of the Ram Foot. The reason is because when you start to break the bead on one side of the wheel, it is putting the steel cord (Bead Bundle) in hoop tension, and you are essentially stretching it. The stock Ram Foot can withstand a tip load of at least 2,000 lbs, but in some cases these tightly fitting tires can exceed even that. Some wheel types (such as Sprint Cars) have a very tight interference between the Tire and Wheel, and the force required to break the bead is very high. On very old and stubborn tires, you may need to use the tool 3-4 times around the rim. If you cannot break the remainder of the tire bead loose by hand, move the BeadBuster XB-550 HD to another location on the rim, adjacent to where the bead is broken. As with any tool, use care while operating the BeadBuster.Ĩ. After you get the feet fully inserted, back off of the clamp bolt until the BeadBuster XB-550 HD is realigned perpendicular to the rim, but still fully inserted. BeadBuster XB-450 ATV/Motorcycle / 4x4 / Lawn Mower Bead Breaker Tool 4.6 out of 5 stars 661 119. BeadBuster-XB-550 BeadBuster Mount lubricant paste BeadBuster Tire Irons More Cancel. Often, in order to get the feet fully inserted, you have to 1st clamp so much that the tool does lean into the rim, which is OK. The BeadBuster XB-450 is our original motorcycle bead breaker, 1st released in October 2012. If Under-Clamped and leaned away from the rim, the Ram Foot could slide down the sidewall and possibly damage the tire. ![]() This is the most common problem users have with using the BeadBuster.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |